Therma-tru Doors Installation User Manual download pdf (Page 55)

Installation

SITE 1 2014 1.55

Elliptical Transom Casing Instructions

Elliptical Transom Casing Installation Instructions

1750 Indian Wood Circle Maumee, Ohio 43537 419-891-7400

3. REMOUNT CASING AND

ATTACH PERMANENTLY

Work from center toward outside

ends as in Step 1. Drive and set

all nails.

2. MARK AND TRIM ENDS

Attach ends of transom casing. Use square cut

pieces of straight jamb casing and mark ends of

elliptical casing for trim cuts.

Pull nails carefully. Remove casing from wall

and trim ends.

1. TEMPORARILY ATTACH CASING

Before installing, mark casing for finish nail locations.

Mark for outer and inner nails.

With transom installed in wall, place casing against transom

frame. Position casing at center for desired reveal from frame

edge. Tack in place at the top two center finish nail locations

only. Do not drive nails fully. They will be pulled back out

in Step 2.

Work from center out. Adjust casing so reveal margin is the

same at each nailing point. Tack at each inner nail location.

Mark and trim ends

The curvature and fit of the casing may

not appear to match the transom frame

shape, if the two are compared before

installation. Do not be concerned. The

casing will flex and is fit to the frame at

installation time.

Casing is furnished with a small amount of

extra length at each end. This will need to

be trimmed at installation time.

Complete installation of this elliptical

casing before doing the straight vertical

sides.

Therma-Tru Doors is an operating company of Fortune Brands, Inc.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 75 76

No comments

Therma-tru Doors Installation User Manual Page 55