Therma-tru Doors Installation User Manual download pdf (Page 21)

Installation

SITE 1 2014 1.21

Multi-Point Lock

Quick Tip Sheet & Instructions

Exterior

Lever Handle

Exterior

Backplate

Gasket

Interior of

Door Stile

Gasket

Interior

Backplate

2” Phillips Head Brass Screws

(Two or Three Provided

Depending on the Backplate)

Nylon

Bushing

Interior

Lever Handle

Set Screw

(Two Provided)

Lock Cylinder

Thumbturn

2” Phillips Head

Cylinder Screw

(One Provided)

Mishandling

Device

Required Shaft

Position for Set

Screw

Construction

Handle

A Phillips screwdriver is required.

A Hex wrench for set screws is

provided in the hardware package

To prevent damage to the handle set

while in the construction phase, use

the enclosed construction handle to

operate the door. Lift to engage

multipoint to close door. Push down

to open the door.

Use water to clean. Do not use brass

cleaner as it will remove the

protective coating. Brass Strike

Plates are Solid Brass and can be

polished as needed.

Note: Handles and backplates vary

by style but application is the same.

1. Apply the backplate gasket to the inside of the

exterior backplate. Push gaskets rmly into place to

ensure a tight seal. Attach interior and exterior

backplates to the door and fasten loosely with the

screws provided. Note: The screw heads must be

on the interior side of the door.

2. Mount nylon bushings to door gear handle hole on

interior and exterior backplates.

3. Insert the two piece handle shaft into one handle. Be

sure to orient the shaft as shown below. Screw the

set screw until ush with handle using the allen

wrench provided. Insert the handle with the shaft

through the backplate and door gear handle hole

until extending out opposite side of door.

4. Install remaining handle onto shaft, pressing tightly to

the backplates. Tighten the handle set screw with

the allen wrench. Screw until ush with handle.

5. Attach thumbturn to cylinder.

6. Insert the keyed cylinder from the interior side of the

door until it is ush with the exterior backplate. Install

the cylinder screw in the screw hole below the

deadbolt in the edge of the door. If passive deadbolt

will not turn, it is installed incorrectly. See Installation

Instructions for active & passive 90-Degree Cylinder.

7. Tighten the backplate screws.

Swing Door Handle Set Installation Instructions

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 75 76

Comments to this Manuals

No comments

Therma-tru Doors Installation User Manual Page 21

Comments to this Manuals

Related products and manuals for For Home Therma-tru Doors Installation