PATIODOORSYSTEMS®Therma-TruHinged PatioDoor SystemSingle PanelUnit AssemblyRead all instructions before starting.The applicable standards for these pr
FRAME ASSEMBLY - continued7Outswing Sill OptionPartially Set Sill Screws in JambsDrive (1) #8 x 2” flat headscrew through holes in bothside jambs unti
FLANGE INSTALLATION8Align and Install Side FlangesAlign edge of side flange with bottomof side jambs.Firmly press into kerf in jamb usinga rubber mall
DOOR INSTALLATION9Place Door into FrameLay frame on flat surfacewith hinges on jamb pointedup as shown.Slide door down on topof skids.Make 2 “Insert S
DOOR INSTALLATION - continued9Engage Hinge KnucklesTap with hammer or rubber mallet asrequired to line up hinge knuckles andengage.Install Hinge PinsT
ATTACH TRANSPORT CLIP10Standard Lock OptionAttach Transport Clip to DoorInsert tab into latch bore.Position reference lip at edge ofstile against exte
ATTACH TRANSPORT CLIP - continuedUNIT READY FOR INSTALLATION1011Attach Transport Clip to FrameClose door into frame ensuringmargins are even at head j
1687 Woodlands Dr. Maumee, OH 435371-800-THERMATRU (843-7628)www.thermatru.comPATIODOORSYSTEMS© 2004 Therma-Tru Corp.Therma-Tru Doors is an opera
Part identificationInswing sill Outswing SillDoor Bottom -InswingDoor Bottom -OutswingStandard HingeAdjustable HingeHead JambLockJambHingeJambHead &am
Part identification - continuedTools/materials required#10 x 3/4”flat head screw#8 x 1-1/4”flat head screw#8 x 3/4”wafer head screw#10 x 2-1/2”flat he
12REMOVE COMPONENTS FROM PACKAGINGATTACH HINGES TO DOORNOTE:Product that is purchased with the multi-point lock system will have additional instructio
23ATTACH HINGES TO DOOR - continuedINSTALL DOOR BOTTOMAdjustable Hinge Option#8 x 1-1/4”Attach hinge to doorLocate the “H” and “V” markings on hinges.
INSTALL WEATHERSTRIPApply Weatherstrip to Active Frame PartsPress in kerf with hand.Trim Bottom EndTrim weatherstripas shown.Lock JambsHinge JambsHead
INSTALL STRIKES5Fasten Security StrikeAssembly to Lock JambFasten with (2) #9 x 3/4" flat headscrews or (2) 16 gauge 1/2" x 7/16"crown
ATTACH HINGES TO JAMB6Fasten Hinges to Hinge JambPlace hinges into hinge mortise.Pre-drill 1/8” dia. pilot holes throughjamb.Fasten top hinge with (2)
FRAME ASSEMBLY7Fasten Side Jambs to Head JambButt and align head jamb to side jambs.Pre-drill 1/8” dia. pilot holes through sidejamb into head jamb.Fa
Comments to this Manuals